What methods are used in flue gas treatment engineering to treat flue gas? As shown below:

1、 Activated carbon adsorption: This waste gas treatment method is usually applied to low concentration waste gas. The main principle is to let the waste gas pass through a device equipped with an adsorbent, which is usually activated carbon, polymer, silicone gel, etc. There are many substances that can be used as adsorbents, but most adsorbents have strong adsorption effects, and the activated carbon adsorption method has an effect on most waste gases, so it is also widely used.

2、 Dilution diffusion method: This method is close to being phased out, but at the beginning of the founding of the People's Republic of China, dilution diffusion method was the 'pioneer' of waste gas treatment. The main process is to send the foul odor gas to a high place through a chimney or mix it with normal gas to achieve the purpose of dilution and purification. This method treats the symptoms rather than the root cause, and is now almost invisible.

3、 Water absorption method: Close contact is made between waste gas that is easily soluble in water and water, so that gases with a foul odor will be absorbed by water. This method has lower operating costs and simpler technology, but the treatment efficiency is average, and it will produce secondary pollution.

4、 UV photolysis method: This waste gas treatment method is the most widely used in China, mainly due to the role of photolysis in decomposing the waste gas to achieve purification.

What methods are used in flue gas treatment engineering to treat flue gas? The above is the method for treating flue gas in Linyi flue gas treatment project. I hope it can be helpful to everyone!